Nokea
A 25-cm spring stretches to 28 cm when a force of 12 N is applied. What would its length be if that force were doubled?
- A. 31 cm
- B. 40 cm
- C. 50 cm
- D. 56 cm
Correct Answer: A
Rationale: When the 12 N force stretches the spring from 25 cm to 28 cm, it causes a length increase of 28 cm - 25 cm = 3 cm. Therefore, each newton of applied force causes an extension of 3 cm / 12 N = 0.25 cm/N. If the force is doubled to 24 N, the spring would extend by 24 N 0.25 cm/N = 6 cm more than its original length of 25 cm. Thus, the new length of the spring would be 25 cm + 6 cm = 31 cm. Choice A, 31 cm, is the correct answer as calculated. Choices B, C, and D are incorrect as they do not consider the relationship between force and extension in the spring, leading to incorrect calculations of the new length.
You may also like to solve these questions
In a circuit with three same-size resistors wired in series to a 9-V power supply, producing 1 amp of current, what is the resistance of each resistor?
- A. 9 ohms
- B. 6 ohms
- C. 3 ohms
- D. 1 ohm
Correct Answer: C
Rationale: In a series circuit, the total resistance is the sum of the individual resistances. With a total voltage of 9 V and a current of 1 A, we can use Ohm's Law (V = I R) to find the total resistance: Total resistance = 9 V / 1 A = 9 ohms. Since the resistors are identical and wired in series, the total resistance is evenly divided among the three resistors: Resistance of each resistor = 9 ohms / 3 = 3 ohms. Thus, the resistance of each resistor is 3 ohms. Therefore, the correct answer is 3 ohms. Choice A, 9 ohms, is incorrect because this would be the total resistance of all three resistors combined in series. Choice B, 6 ohms, is incorrect as it does not account for the equal distribution of resistance in a series circuit. Choice D, 1 ohm, is incorrect as it is too low for resistors in series with a total resistance of 9 ohms.
What force was applied to the object that was moved if 100 Nâ‹…m of work is done over 20 m?
- A. 5 N
- B. 80 N
- C. 120 N
- D. 2,000 N
Correct Answer: A
Rationale: Work is calculated using the formula Work = Force x Distance. Given that 100 Nâ‹…m of work is done over 20 m, we can rearrange the formula to solve for Force. Force = Work / Distance. Plugging in the values, we get Force = 100 Nâ‹…m / 20 m = 5 N. Therefore, the force applied to the object that was moved is 5 N.
Choice B (80 N) is incorrect because it doesn't match the calculated force of 5 N. Choice C (120 N) is incorrect as it is higher than the calculated force. Choice D (2,000 N) is incorrect as it is significantly higher than the correct force of 5 N.
Which conclusion can be drawn from Ohm's law?
- A. Voltage and current are inversely proportional when resistance is constant.
- B. The ratio of the potential difference between the ends of a conductor to current is a constant, R.
- C. Voltage is the amount of charge that passes through a point per second.
- D. Power (P) can be calculated by multiplying current (I) by voltage (V).
Correct Answer: B
Rationale: Ohm's law states that the ratio of the potential difference (voltage) between the ends of a conductor to the current flowing through it is a constant. Mathematically, this is represented as V = I x R, where V is voltage, I is current, and R is the constant resistance. Therefore, the correct conclusion that can be drawn from Ohm's law is that the ratio of the potential difference between the ends of a conductor to current is a constant, denoted as R. This relationship is fundamental to understanding the behavior of electrical circuits and the effect of resistance on voltage and current. Choice A is incorrect because Ohm's law actually states that voltage and current are directly proportional when resistance is constant. Choice C is incorrect because voltage is not the amount of charge that passes through a point per second; rather, it is the electric potential energy per unit charge. Choice D is incorrect because although power (P) can be calculated by multiplying current (I) by voltage (V), this is not a conclusion directly drawn from Ohm's law.
When a dielectric material is inserted between the plates of a charged capacitor, what will happen to the capacitance?
- A. Increase
- B. Decrease
- C. Remain the same
- D. Become unpredictable
Correct Answer: A
Rationale: When a dielectric material is inserted between the plates of a charged capacitor, the capacitance will increase. This is because the presence of a dielectric material reduces the electric field between the plates, allowing more charge to be stored for a given voltage, thus increasing the capacitance. Choice B is incorrect because adding a dielectric material increases capacitance. Choice C is incorrect because capacitance changes when a dielectric is added. Choice D is incorrect because the effect of a dielectric on capacitance is predictable.
Fluid dynamics is a subfield of fluid mechanics concerned with:
- A. Equilibrium properties of fluids at rest (Fluid Statics)
- B. The motion and behavior of fluids under various conditions
- C. Phase transitions of fluids between liquid, gas, and solid states
- D. Engineering applications of fluids (related but broader than fluid dynamics)
Correct Answer: B
Rationale: Fluid dynamics is the study of fluids in motion and their behavior under different conditions, including how they flow, mix, and interact with their surroundings. It focuses on the dynamic aspects of fluids rather than their static properties when at rest, which is the realm of fluid statics. Phase transitions of fluids between liquid, gas, and solid states are more related to thermodynamics than fluid dynamics. While engineering applications involve fluid dynamics, the field itself is more specialized in studying the movement and behavior of fluids.